ESPHome-Devices

Kogan Smart Air Purifier 2S

Kogan Smart Air Purifier 2S

Device Type: misc
Electrical Standard: au

Product Image

Product Listing

Flashing Tips (Home Assistant Thread).

Tear down, mods/enhancements, Home Assistant configs, and more detailed write up (Home Assistant Thread)

GPIO Pinout

PinFunction
GPIO13RX
GPIO15TX

Basic Config

substitutions:
name: kogan-air-purifier
esphome:
name: "${name}"
platform: ESP8266
board: esp01_1m
wifi:
ssid: "YourSSID"
password: "YourWifiPassword"
# Enable logging
logger:
baud_rate: 0
# Enable Home Assistant API
api:
# Allow OTA updates
ota:
uart:
#Serial connection between the TYWE1S and the Tuya MCU
- id: uart_0
rx_pin: GPIO13
tx_pin: GPIO15
baud_rate: 9600
#Tuya component: https://esphome.io/components/tuya.html
tuya:
uart_id: uart_0
#Tuya Fan: https://esphome.io/components/fan/tuya.html
fan:
- platform: tuya
name: ${kogan-air-purifier}
switch_datapoint: 1 #ON, OFF
speed_datapoint: 4 # 0 = off, 1 = sleep, 2 = high, 3 = auto
speed_count: 3
number:
#19 Timer Mode
- platform: tuya
name: "${name} Timer Mode"
number_datapoint: 19 # 0 = off, 1 = 4hr, 2 = 8hr
min_value: 0
max_value: 2
step: 1
#20 Timer Countdown
- platform: tuya
name: "${name} Timer Countdown Mins"
number_datapoint: 20 #counts down from inital timer mode value of 4hr = 240min or 8hr = 480min
min_value: 0
max_value: 480
step: 1
#101 LED Brightness
- platform: tuya
name: "${name} LED Brightness"
number_datapoint: 101 #0 = off, 1 = mid, 2 = high
min_value: 0
max_value: 2
step: 1
#22 Air Quality Level
- platform: tuya
name: "${name} Air Quality Level"
#Only seems to report air quality when in auto mode. 0 = Good, 1 = Yellow/Poor ,2 = Red/Bad
number_datapoint: 22
min_value: 0
max_value: 2
step: 1
#5 Unknown
# - platform: tuya
# name: "${name} DP5 Unknown" #Unknown. Could be % filter Left?
# number_datapoint: 5
# min_value: 0
# max_value: 200
# step: 1
#11 Unknown
# switch:
# - platform: tuya
# name: "${name} DP11 Unknown" #Unknown. Could maybe be reset button or wifi connection?. Have not tested.
# entity_category: config
# switch_datapoint: 11
Edit this page on GitHub