ESPHome-Devices

Etekcity Smart Outdoor WiFi Outlet Plug ESO15-TB

Etekcity Smart Outdoor WiFi Outlet Plug ESO15-TB

Device Type: plug
Electrical Standard: us

Converted from Tasmota.

Etekcity Site

Flashing

Remove the four phillips head screws and remove the plastic clamshell. Then, remove a few more screws to remove the circuitry from the plastic enclosure. The Rx, Tx, 3.3v, and Ground solder pads will then be visible to use. GPIO0 (Pin 8) must be grounded on boot to place the device into boot loader mode.

GPIO Pinout

PinFunction
GPIO4Relay 1
GPIO5Relay 2
GPIO9Led 1
GPIO12HLW8012 CF1
GPIO13HLW8012 CF
GPIO14Button 1
GPIO15HLW8012 SEL
GPIO16Led 2

Basic Configuration

# Etekcity Smart Outdoor WiFi Outlet Plug (ESO15-TB)
substitutions:
device_name: eso15_tb
device_description: ESO15 TB Outlet 1
friendly_name: Outdoor Outlet 1
esphome:
name: ${device_name}
comment: ${device_description}
platform: ESP8266
board: esp01_1m
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
fast_connect: True
# Enable fallback hotspot (captive portal) in case wifi connection fails
ap:
ssid: ${device_name} Fallback Hotspot
password: !secret ap_password
captive_portal:
# Enable Home Assistant API
api:
password: !secret api_ota_password
encryption:
key: !secret encryption_key
ota:
password: !secret api_ota_password
# Enable logging
logger:
sensor:
- platform: hlw8012
sel_pin: GPIO15
cf_pin: GPIO13
cf1_pin: GPIO12
current:
name: "${friendly_name} Current"
voltage:
name: "${friendly_name} Voltage"
power:
name: "${friendly_name} Power"
energy:
name: "${friendly_name} Energy"
- platform: wifi_signal
name: "${friendly_name} WiFi signal"
update_interval: 60s
- platform: uptime
name: "${friendly_name} Uptime"
update_interval: 60s
binary_sensor:
- platform: gpio
pin:
number: 14
mode: INPUT_PULLUP
inverted: true
id: button1
on_multi_click:
- timing:
- ON for at most 1s
- OFF for at least 0.5s
then:
- logger.log: "Single Clicked"
- switch.toggle: outlet_a
- timing:
- ON for at most 1s
- OFF for at most 1s
- ON for at most 1s
- OFF for at least 0.2s
then:
- logger.log: "Double Clicked"
- switch.toggle: outlet_b
- platform: status
name: "${friendly_name} Status"
switch:
- platform: gpio
pin: GPIO4
name: "${friendly_name} Outlet A"
id: outlet_a
on_turn_on:
- output.turn_on: led1_output
on_turn_off:
- output.turn_off: led1_output
- platform: gpio
pin: GPIO5
name: "${friendly_name} Outlet B"
id: outlet_b
output:
- id: led1_output
platform: gpio
pin: GPIO9
status_led:
pin:
number: GPIO16
Edit this page on GitHub