devices.esphome.io

AVATTO S06 WiFi IR Universal Remote Controller (No Temp/No Humidity)

AVATTO S06 WiFi IR Universal Remote Controller (No Temp/No Humidity)

Device Type: misc
Electrical Standard: global
Board: esp8266

Product Image

GPIO Pinout

PinFunction
GPIO4Blue Status LED
GPIO14Remote Transmitter
GPIO5Remote Receiver
GPIO13Reset Button

Getting it up and running

This device needs very likely to be flashed manually. Tuya-convert didn't worked for me. I have powered the device with a mobile charger during the flashing procedure, as the used serial cable sets to logic level based on the input voltage. Which is 3.3V in this case.

SerialESP
RXTX
TXRX
RTSRESET
3.3V3.3V
GNDGND
GPIO0 (GND)

Flashing

# Create a backup of the original firmware
esptool.py -p /dev/ttyUSB0 -b 460800 read_flash 0x00000 0x100000 avotta_s06_original_firmware.bin
# Erase the flash
esptool.py -p /dev/ttyUSB0 erase_flash
# Upload the esphome firmware
esptool.py -p /dev/ttyUSB0 write_flash -fs 1MB 0x0 ir_remote.bin

Hardware Hack

If you want to wake the device via the reset button on the bottom from deep sleep. You need to solder a peace of wire between the GPIO13 and the RESET pin of the ESP8266 MCU.

Configuration

# Basic Config
---
# https://esphome.io/devices/esp8266.html
esphome:
name: ir_remote
platform: ESP8266
board: esp01_1m
wifi:
ssid: !secret ssid
password: !secret wlan_password
fast_connect: true
# Enable fallback hotspot (captive portal) in case wifi connection fails
ap:
ssid: IR Remote Fallback Hotspot
password: !secret ap_password
captive_portal:
# Enable logging
logger:
level: DEBUG # Default
# Enable Home Assistant API
api:
encryption:
key: !secret api_encryption_key
ota:
password: !secret ota_password
# https://esphome.io/components/status_led.html
status_led:
pin: 4
# https://esphome.io/components/remote_receiver.html
remote_receiver:
id: rcvr
pin:
number: 5
mode: INPUT_PULLUP
inverted: True
# https://www.esphome.io/components/remote_transmitter.html
remote_transmitter:
id: tamtr
pin: 14
carrier_duty_percent: 50%
# https://esphome.io/components/climate/ir_climate.html
climate:
- platform: toshiba
id: ac
name: AC'
receiver_id: rcvr
transmitter_id: tamtr
switch:
- platform: template
name: 'AC Preset'
id: ac_preset
icon: mdi:cached
turn_on_action:
- climate.control:
id: ac
mode: COOL
target_temperature: 24°C
fan_mode: AUTO
swing_mode: VERTICAL
# https://esphome.io/components/switch/shutdown.html
- platform: shutdown
name: "IR Remote Shutdown"
id: ir_remote_shutdown
Edit this page on GitHub