devices.esphome.io

Sonoff RF Bridge

Sonoff RF Bridge

Device Type: Misc
Electrical Standard: global
Board: esp8266

GPIO Pinout

PinFunction
GPIO13Blue LED (HIGH = off, LOW = on)
GPIO0Button 1
4Remote Receiver
5Remote Transmitter

Basic Configuration

# Basic Config
esphome:
name: sonoff_rf_bridge01
platform: ESP8266
board: esp01_1m
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
logger:
api:
ota:
# Device Specific Config
binary_sensor:
- platform: status
name: "RF Bridge Status"
# use esphome log viewer to get binary transmission for sensor state. Below are examples when using either single state or dual state sensors.
# use this for single state sensors (single trigger)
- platform: remote_receiver
name: "Sensor1"
rc_switch_raw:
code: '100110011100011010101001'
protocol: 1
# use this for dual state sensors (open/closed trigger)
- platform: remote_receiver
name: "Sensor 2 Open"
internal: yes
rc_switch_raw:
code: '001111111110111100101110'
protocol: 1
on_press:
- binary_sensor.template.publish:
id: Sensor2
state: ON
- platform: remote_receiver
name: "Sensor 2 Closed"
internal: yes
rc_switch_raw:
code: '001111111110111100100111'
protocol: 1
on_press:
- binary_sensor.template.publish:
id: Sensor2
state: OFF
- platform: template
name: "Sensor2 State"
device_class: window
id: Sensor2
remote_receiver:
pin: 4
# dump: all
dump: rc_switch
filter: 100us
tolerance: 50%
idle: 2ms
remote_transmitter:
pin: 5
carrier_duty_percent: 100%
status_led:
pin:
number: GPIO13
inverted: yes
Edit this page on GitHub