devices.esphome.io

DETA Grid Connect Smart Inline Switch 6000HA

DETA Grid Connect Smart Inline Switch 6000HA

Device Type: plug
Electrical Standard: au
Board: esp8266

General Notes

The DETA Smart Inline Switch are made by Arlec as part of the Grid Connect ecosystem, and are sold at Bunnings in Australia and New Zealand. They can be flashed without disassembly or soldering using tuya-convert if still old stock, newer stock with updated Tuya firmware require dissassembly, soldering and flashing via serial.

GPIO Pinout

PinFunction
GPIO1Button
GPIO13Blue LED
GPIO14Relay

Getting it up and running

Tuya Convert

These switches are Tuya devices, so if you don't want to open them up to flash directly, you can use tuya-convert to initially get ESPHome onto them. After that, you can use ESPHome's OTA functionality to make any further changes.

  • Put the switch into "smartconfig" / "autoconfig" / pairing mode by holding any button for about 5 seconds.
  • The status LED blinks rapidly to confirm that it has entered pairing mode.

Basic Configuration

# Basic Config
# https://www.bunnings.com.au/deta-grid-connect-smart-inline-switch_p0098816
substitutions:
device_name: "deta_smart_inline_switch_1"
name: "Deta Smart Inline Switch 1"
esphome:
name: ${device_name}
comment: ${name}
platform: ESP8266
board: esp01_1m
board_flash_mode: dout
esp8266_restore_from_flash: true
wifi:
networks:
- ssid: SSID
password: Password
- ssid: SSID Secondary
password: Password
ap:
ssid: ${device_name} Hotspot
password: "Password"
captive_portal:
logger:
#level: VERBOSE
api:
ota:
web_server:
port: 80
time:
- platform: homeassistant
id: homeassistant_time
output:
- platform: esp8266_pwm
id: blue_led_output
pin:
number: GPIO13
inverted: True
light:
- platform: monochromatic
name: ${device_name} Blue LED
output: blue_led_output
id: blue_led
internal: True
sensor:
- platform: uptime
name: ${device_name} Uptime
- platform: wifi_signal
name: ${device_name} Wifi Signal
update_interval: 60s
text_sensor:
- platform: version
name: ${device_name} ESPhome Version
- platform: wifi_info
ip_address:
name: ${device_name} IP
binary_sensor:
- platform: gpio
pin:
number: GPIO1
inverted: True
id: button
name: ${device_name} Button
on_press:
- switch.toggle: relay_template
internal: True
switch:
- platform: gpio
pin: GPIO14
id: relay
# tie the led & relay operation together and report status based on relay state
- platform: template
name: ${device_name} Relay
id: relay_template
lambda: |-
if (id(relay).state) {
return true;
} else {
return false;
}
turn_on_action:
- light.turn_on: blue_led
- switch.turn_on: relay
turn_off_action:
- light.turn_off: blue_led
- switch.turn_off: relay
Edit this page on GitHub